Rajkot jewellery casting and micro plating workshops are specialist units that supply the makers whose names you see on catalogues. Most Rajkot jewellery is not made in one building: a maker designs and manages the order, but casting, plating and setting are often done by separate units nearby.
That structure is a strength, because each unit does one thing well, but it also means your order depends on how well the maker manages those units.
What do casting workshops do?
Casters pour molten brass or alloy into moulds to make the raw shape. Some use gravity or centrifugal casting; others stamp sheet metal in a press. Casting, stamping and die making explained describes the methods.
A caster's skill shows in detail sharpness, absence of pores and consistent weight. Pores and rough surfaces show up later as plating bubbles, so they cost you at the end of the line.
What does micro plating mean?
Micro plating is a very thin plating layer, measured in fractions of a micron to a few microns. What micro gold plating is explains the term. It gives a bright gold, silver or rose colour at low weight of precious metal.
The trade-off is wear. Thin layers fade with skin contact. A good plater controls bath chemistry, time and cleaning, and applies a protective coating where needed. Ask for a thickness reading, not just the word micro.
Who does what in the chain
A typical order passes through several hands:
- The maker or design house takes your brief, controls the sample and manages production.
- The die maker or mould maker prepares the tools.
- The caster or stamping unit produces the raw metal parts.
- A finishing unit files and polishes the pieces.
- The plating unit applies the colour layers and any coating.
- Setters add stones and assemble the pieces.
- A packing unit counts, tags and packs.
Why it matters to you
Delays and defects often start at one link, such as a caster with a backlog or a plater whose bath has aged. A maker who manages these units well has fewer surprises. Ask who does the casting and plating for your design, and ask to see them.
Mould ownership also matters. If your design sits in a caster's workshop, find out who controls it. See jewellery mould ownership in Rajkot.
What should you ask your maker about these units?
Ask who casts your pieces, who plates them and whether those units also work for other brands. Ask how the maker checks incoming castings and plated pieces, and what is done with rejects.
A maker with a clear inspection step between units catches problems early. One without it passes faults down the line until a buyer finds them. Ask to see rejected pieces on the shop floor; a workshop that has none is either lucky or not looking. Where possible, visit the plating unit yourself, since the condition of the baths and the cleanliness of the room say a great deal.
Next step
We trace your order through every unit and check quality at each step. To discuss it, book a free sourcing review.